Your shopping cart is empty!
Switch Mode Power Supply, suitable for all USB GEM controllers except the GEM-CX.
0 reviews / Write a review
Swarf Extractor to fit the spindle housing on the GEM-FX, FX4, FX5, RX, RX4, TX and RX5. Ready ..
Standard 11/64th brass cutter knob (left hand thread)...
Replacement Acetyl Nose Cones used to regulate the depth of cut when deep engraving, available..
General purpose 2mm wrench...
General purpose 3mm wrench...
Replacement spindle drive belt for the GEM-RX, FX, TX, ZX and VX4 series of machines...
Acetyl Vernier and Nose Cone for use to control the depth when deep engraving. This accessory only f..
Brushless Spindle Motor for the GEM-RX, GEM-RX4, GEM-FX, TX, ZX and GEM-FX4 only. It is advisab..
Replacement Spindle for the U-MARQ GEM-FX, GEM-TX, GEM-ZX, GEM-RX and GEM-VX4 series of en..
High quality replacement spindle bearings for the U-MARQ GEM-RX, GEM-FX, GEM-TX, GEM-ZX and GEM..
The GEM Spindle Spanner is used to hold the spindle whilst removing the cutter holder...
Balanced sprung cutter knob for use with diamond cutters, gives a lighter cut. This product can..
Replacement Inside/Outside Ring engraving chuck. This comes complete with specially machined jaws an..
Bobbins used for holding the item on the Bangle attachment, fitted with M3 stud...
The GEM-RX Rotary Spanner Set is used to hold the rotary axis whilst removing the penholder, ri..
Acetyl Pen Drive Bush, fits the driven end, suitable for the GEM-2, GEM-RX series&nbs..
GEM-RX series Pen Support Bush, fits in the tailstock...
Complete Tailstock for the GEM-2, and GEM-RX series. Not include pen support bush, (Part No. SP..
GEM-2 and GEM-RX series stainless steel tail stock Clamp Strip...
Replacement stepper motor for "X", "Y", "Z" and "U" axe..
10” x 8” plastic sheet used to protect the machines’ flatbed table during the cutt..
11/64th x 6.5" conical drag diamond, general purpose for use with all metals, available in two sizes..
Solid Micrograin carbide cutter 11/64'' x 6.50'' for general use on plastics an..
To be used for glass engraving and creating cutouts on precious metals...
11/64" x 6.5" Rotated Burnishing Diamonds have a diamond with polished cutting facets..